Why does the Ariston washing machine show error F07 on the display? The reason is that the heater is not covered by water. Learn how to fix the problem and remove the error code yourself.
Electromechanical AGRs indicate the malfunction code by blinking of bulbs “Super wash” - “Quick wash” - “Extra rinse”.
Below we will analyze in detail what the error means, and what to do if it occurs.
How to fix the error
If error F 07 is lit on the display of the Ariston or Hotpoint-Ariston washing machine, try to solve the problem with simple steps:
- Do not rule out the possibility of a system crash. To reset the F07 error, you need to de-energize the SM Ariston, and then turn it on again after 20 minutes. The error is gone - the reason is a failure, it is highlighted again - try other options.
How to fix the breakdown of Ariston and Hotpoint Ariston washing machines
For AVL and AVD type washers with EVO-II controller:
- Check if the pressostat connector J3 is connected to the electronic module. It happens that the wires leave or burn out due to sudden surges in electricity. It may be necessary to solder or replace damaged areas.
- Inspect the pressure switch for damage. Malfunctions are detected, so you need to replace the part.
- Check the heater by measuring with a multimeter. If everything is in order with the heater, at 1800 W it will show a resistance of about 25 Ohms. What to do if the heater does not pass the test? Will have to replace it.
- If the reason is the controller of the control board, it will need a repair or a complete replacement.
Ariston "Margarita 2000" washing machines (AL and ALS) with EVO-I controller:
- Inspect the wiring for a contact in the connector of the CM1 electrical module.
- Diagnose the heater relay on the controller.
- Replace the electronic module if necessary.
If nevertheless the heater did not pass the test, and the machine gives an error F 07, which indicates its malfunction, we will tell you how to replace the heating element.
How to remove and replace the heater
To remove the error and return the washing machine to normal operation, proceed:
- If you checked the heater as indicated in paragraph 3, then all the wires have already been disconnected.
- Using a wrench, unscrew the mounting nut under No. 1 in the photo.
- Press the remaining hairpin (No. 2) firmly, recessing inward.
- Since the heater is sealed with rubber, pry it off the edge (in photo No. 3)
- A working heater is installed in the reverse order.